Front Control Panel - Mitsubishi Electric WD-73727 Owner's Manual

Front Controm Panel
The shaded buttons on the front controi panei are dupiicated on the remote control The top row of iabeis shows the
controi functions when there are no TV menus dispiayed on the screen. The bottom row of iabeis shows the controi
functions when the TV menus are dispiayed on the screen or when a speciai function has been activated. See "Remote
Controi Overview" for further detaiis on the functions of these buttons.
LAMP S_/q'US "rIMER
m
Modeis WD-52628, WD-62628
LAMP
Modei WD-73727
Front Control Panel
1. Shaded buttons dupficate buttons on the remote contro/ 2. System Reset 3. Lamp indicator
4. Status indicator 5. Power/Timer indicator
If the TV does not respond to either the remote controi or the front panei controis and/or
does not power off, press the SYSTEM RESET button with a pointed item, such as the end
point of a paperciip. The TV will turn off and the TIMER light will flash quickly for about one
minute. When the TIMER light stops flashing, you may again turn on the TV. The changes
you made the last time the TV was on before you used the SYSTEM RESET button may be
lost. Any changes that you previously saved are not lost.
Front-PaneJ indicator Lights
None (indicator off)
Green, rapid blinking
Red, steady
Normal TV on or standby condition.
TVjust powered off and lamp is
cooling.
Lamp nearing end of useful life.
1. Lamp access door is open or not
secure.
2. No lamp installed.
Lamp no longer illuminates and has
reached the end of the lamp life.
Normal operation.
Begins to blink 30 seconds after turning off TV. TV
can be turned on before it begins to blink or after the
blinking stops, but not while the indicator is blinking.
Normal operation.
This is a recommendation to have a new lamp ready
before the current lamp stops illuminating. See
Appendix H for ordering information.
TV wiii not operate until lamp access door is secure.
See Appendix H for installation information.
TV wiii not operate without a lamp. See Appendix H
for installation information.
Replace the lamp. The TV will not operate when
the lamp no longer illuminates. See Appendix H for
installation information.
12 Ohapter 1. Television Overview