Front Control Panel - Mitsubishi Electric TM WD-62827 Owner's Manual

Front Control Panel

The shaded buttons on the front control panel are duplicated on the remote control. The top row of labels shows the
control functions when there are no TV menus displayed on the screen. The bottom row of labels shows the control
functions when the TV menus are displayed on the screen or when a special function has been activated. See "Remote
Control Overview" for further details on the functions of these buttons.
1

Front Control Panel

1. Shaded buttons are duplicates of buttons on the remote control
4. Status indicator 5. Power/Timer indicator
A/ V Reset
There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To return
all the settings at once, press GUIDE and FORMAT on the front panel at the same time. To reset the defaults for
individual devices, use the A/V Memory Reset selection on the Audio/Video menu.
Front-Panel Indicator Lights
Lamp Indicator
Indicator Color TV Condition
None (indicator off) Normal TV on or standby condition.
Green, rapid blinking TV just powered off and lamp is
cooling.
Yellow, steady Lamp nearing end of useful life.
Yellow, blinking 1. Lamp access door is open or not
2. No lamp installed.
Red, steady Lamp no longer illuminates and has
reached the end of the lamp life.
1
Chapter 1. Television Overview
3 
If the TV does not respond to either the remote control or the front panel controls and/or
does not power off, press the SYSTEM RESET button with a pointed item, such as the end
point of a paperclip. The TV will turn off and the TIMER light will flash quickly for about one
minute. When the TIMER light stops flashing, you may again turn on the TV. The changes
you made the last time the TV was on before you used the SYSTEM RESET button may be
lost. Any changes that you previously saved are not lost.
secure.
1 5 5 2
2. System Reset
Additional Information
Normal operation.
Begins to blink 30 seconds after turning off TV. TV
can be turned on before it begins to blink or after the
blinking stops, but not while the indicator is blinking.
Normal operation.
This is a recommendation to have a new lamp ready
before the current lamp stops illuminating. See
Appendix G for ordering information.
TV will not operate until lamp access door is secure.
See Appendix G for installation information.
TV will not operate without a lamp. See Appendix G
for installation information.
Replace the lamp. The TV will not operate when
the lamp no longer illuminates. See Appendix G for
installation information.
1
3. Lamp indicator