Front Control Panel - Mitsubishi Electric WD-52525 Owner's Manual

Front Control Panel

������
����� ���� ������ �����
The buttons on the Front Control Panel highlighted in gray are duplicated on the remote control. The top row of
labels show the control functions when there are no TV menus displayed on the screen. The bottom row of labels
show the control functions when the TV menus are displayed on the screen or when a special function has been
activated. See Remote Control Overview, for further details on the functions of these buttons.
System Reset
If the TV will not respond to either the remote control or the front panel controls and/or will not power Off, press the
SYSTEM RESET button with a pointed item like the end point of a paperclip. The TV will turn Off and the TIMER
light will flash quickly for about one minute. When the TIMER light stops flashing, you may again turn on the TV. The
changes you made the last time the TV was on before you used the SYSTEM RESET button may be lost, however,
the changes that were previously saved are not lost.
Indicators
Please refer to the table below for conditions when the indicator lights will display.
COLOR
None (off)
Green (steady light)
Green ( fast blinking
light)
Green (blinking light)
Yellow (steady light)
Yellow (blinking light)
Red (steady light)
Red (blinking light)
*Each time the TV is plugged into a wall electrical outlet, when power is restored after a power failure, or when using
the SYSTEM RESET button, this light will flash for about one (1) minute.
A/V Reset
There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To do
this for an individual setting, use the Audio or Video remote control button. To return all of the settings at once,
press GUIDE and FORMAT on the front panel at the same time, or use the A/V Memory Reset selection on the
AudioVideo menu.
� ��� �
�����
LAMP INDICATOR
Power off
n/a
n/a
Power just turned off, TV
cooling down (1 minute).
Cannot turn the TV back
on until blinking stops.
Lamp life end warning.
A new lamp should be
purchased.
See Appendix H.
Lamp cover door is open
or
no lamp installed.
See Appendix H.
Lamp has failed,
replacement is required.
See Appendix H.
n/a
� �� � ������
� �
������
STATUS INDICATOR
Power off
n/a
n/a
n/a
Operating temperature is too high.
The dust filter may be dirty. See Appendix H.
or
The room temperature too hot. Turn off TV
until the room is cooler.
The filter cover is open or not secure.
See Appendix H.
Service required.
Turn off TV and call your dealer or a
Mitsubishi Authorized Service Center. See
www.mitsubishi.com or call 1-800-332-2119.
Service required.
Turn off TV and call your dealer or a
Mitsubishi Authorized Service Center. See
www.mitsubishi.com or call 1-800-332-2119.
���� �����
�����
���� ������
������
TIMER/
POWER
Power off
Power on
Starting up*
TV Timer is
set
n/a
n/a
n/a
n/a
11