External Devices And Netcommand® Setup - Mitsubishi Electric WD-73727 Owner's Manual

Connecting E×temai Devices and NetCommand® Setup
NetCommand is able to control many current audio and video devices by sending remote control signals from the TV to
each device through IR emitters. Additionally, it can barn the remote control signals used by most audio video devices
not already in the TV's memory. NetCommand can automatically switch the TV and compatible or learned Audio/Video
(A/V) Receivers to the correct input used with each device. It is important that the inputs on the TV and AiV receiver
back panels match the NetCommand setup that is displayed on screen.
To simplify the installation of NetCommand, there is a step-by-step on-screen NetCommand Setup procedure in this
chapter, which details the type and brands of devices you are connecting to the TV. The NetCommand Setup also
assigns preset TV and AiV receiver inputs for each device. You should connect each device to the TV input (both audio
and video) and to the AiV receiver (audio) as shown in the figure below. If you connect devices to inputs other than the
ones shown as presets, you must change the NetCommand setup accordingly. See the Edit NetCommand information
starting on page 45.
Device to be
Lstereo and/or digital
audio cables i
AV
TV Receiver
I stereo and/or audio cables
digital
The following charts show which preset inputs you should use on the TV and AiV receiver.
Chart 1 shows the default TV inputs existing in NetCommand.
Chart 2 shows the AiV receiver inputs used by AiV receiver models already known by NetCommand.
Chart 1
NetOommand Default Device Audio and Video Outputs to TV inputs
Cable for CabmeOARD
TM
Service ANT-f
Antenna/Oabme (digitaVanamog} ANT-I if primary viewing source,
ANT-2 if secondary viewing source
Cable box COMPONENT_f
VCR lnput-f
Satellite Receiver (SAT} Input-2
Camcorder Input-3 (on front panel}
DVD Pmayer COMPONENTs2
PC HDMI=2
Chart 2
After using NetCommand Setup, you may go to the NetCommand menu at any time to change the inputs you used for
connecting each device, custom name devices, add devices not included in the presets above or delete devices no
longer used. See Edit NetCommand. See He/pfu! Hints at the end of this chapter for additional information on device
setup.
22 Chapter2. Connecting