Mitsubishi Electric WD-73727 Owner's Manual page 46

Edit NetCommand®: Add an A!V Receiver, continued
A/V Receiver (AVR) Input Learn Screen
Figure 10
NetCommand can now Heamthe remote centroH signaHs
used to seHect each input on the AiV receiver.
1. Press ADJUST _ or 11_ o n the TV remote to seHect the
check box for each function to be Heamed.
2. Press ENTER and the function name will begin to
flash to confirm the ready-toqeam status.
3. Press the button en the AiV receiver's remote controH
that corresponds to the seHected function. A check
mark will appear and the functien name will stop
flasMng. This confirms the signaH Hearned status.
4. To test the Hearned command, press ENTER on the TV
remote. The AiV receiver will perform the seHected
function. The AiV receiver needs to be turned on
and the IR emitters properHy pHaced for the test to be
successfuH (see page 32 for IR emitter placement).
5. To custemize the input names, press ADJUST _ to
move te the Input Name text box and then press
ADJUST A or Y and ENTER to select each letter of
the name. These names will appear en the Review
screen as the AiV receiver's input names, and should
match the names the AiV receiver shows in its own
display.
6. To erase the learned input signal, highlight the check
box for that input and press CANCEL
7. Repeat for each connected input.
8. When the input selection signals have been learned
and the inputs named, press ADJUST 1_to select
Next> and move to the AiV receiver Learn screen.
Figure 10. AiV receiver Input Learn screen
A/V Receiver (AVR) Learn Screen
Figure I1
1. Press ADJUST A or _' on the TV remote to select the
check box for each function to be learned.
2. Press ENTER and the function name will begin to flash
to confirm the ready-toqeam status.
3. Press the button en the A/V receiver's remote control
that corresponds to the selected function, A check
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
4. To test the learned command, press ENTER en the TV
remote. The AiV receiver will perform the selected
function. The AiV receiver needs to be turned on
and the IR emitters properly placed for the test te be
successful (see page 32 for IR emitter placement).
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box
for that function and press CANCEL
7. When the function signals have been learned, press
ADJUST _ to select Next> and move to the Name
screen.
Figure 11. AiV receiver Leam screen
iMPORTANT
n learning remote control signals, point
device's remote at the TV scree: n
46 Chapter 3. NetCemmand Setup and Editing