Peer-To-Peer Connections - Mitsubishi Electric WD-73727 Owner's Manual

Peer-to-Peer Connections
What is a Peer-to-Peer Connection?
Figure 9
A peePto-peer connection allows the IEEE 1394 devices
in your TV network to taik to each other without the further
need of TV intervention once the peePto-peer connection
is estaMished. With the connection estabiished, you can
turn off the TV or use it to watch another device.
For exampb, the TV can set up a connection for an IEEE
1394 came box that sends a program to another device
for viewing. NetCommand estaMishes the connection
between the two devbes. Set up a recording over a
peer-to-peer connection the same as you wouid any other
NetCommand-controHed recording.
NOTE: Anaiog or tradifionai (non-digitai) devices can
not be used for peer-to-peer connections.
Figure 9. Recording Setup screen for peer-to-peer
connection
Setting up a Non-Recording Peer-to-
Peer Connection
To estaMish a peePto-peer connection:
1_ Select the source in the Device Selection menu.
2_ Press RECORD or CONNECT on the TV remote
control to open the Recording Setup screen.
3_ In the "Record To" section of the Recording Setup
screen, review the destination device and duration of
the connection. Change if necessary.
4_ Press RECORD or CONNECT a second time to
establish the connection.
NOTE: Multiple peePto-peer connections can
operate simultaneously, sometimes with the same
source device. Please note that peer-to-peer
connections are NOT listed on the Record List
screen.
Cancelling a Peer-to-Peer Connection
To cancel a peePto-peer connection:
1_ Press DEVICE to open the Device Selection menu.
2_ Highlight the source device in the Device Selection
menu_
3. Confirm that the on-screen icon for the peer-to-peer
connection is in the Connection Section next to the
TV icon
4_ Press CANCEL
The peer-to-peer connection ends and the destination
icon is removed. If there is more than one peer-to-peer
connection for the same device, all the connections are
cancelled.
Chapter 4. Netcommand Functions 63