Table of Contents
Advertisement
Chapter 2 : Connecting YourVCR
Connecting theAntenna or Cabletothe VCR(conL)
Insert lead under screws
and tighten.
ii
•
i!
--.15/8"1,--
_
/
HI
•
J|
__._
300-75 Ohm Adapter
Wrap each exposed
end of wire once or twice around
the screw
shanks
of the adapter
(or insert the clips 1ruder the screw
heads). Tighten
the screws.
O
Push the adapter
firmly onto the antenna
terminal
on the
VCR labeled ANTENNA
IN.
O
When you are finished,
go to page 15, "Coanecting
the Televi-
sionl
Am_NN---_-
II
g--|I,-
-
A
IC
•
II
connecting anantennawitha 75-ohmroundlead
0
Disconnect
the antenna
from the back of the TV.
Connect
the antenna
to the ANTENNA
IN terminal
on the
back of the VCR. Screw or push the cable until it is tight.
When you are finished,
go to page 15, "Co:_necting
the Televi-
sion."
connectingseparateUHFNHF antennas
You may have two separate
antennas
(one UHF, one VHF) that
bring TV signals into your home. If you do, yoa'll need to combine
the two antennas
into a single wire to connect them to the VCR.
To do this, you'll need an attachment
called a combiner
(which is
available
at your electronics
s_ore).
The chart below will help you determine
the kind of combiner
you
need.
If your UHF antenna wire looks
...and your VHF antenna wire
...ther you need a combiner
like this..,
looks like this...
like thi
To connect your antennas:
(please
see the illustration
on the next page.)
O
Disconnect
the antennas
from the back of Lhe TV.
Connect
the antenna
leads onto the combtaer.
Screw or push the combiner
onto the ANTENNA
IN terminal
on the VCR.
O
When you are finished,
see page 15, =Conr ecting the Televi-
sion. _
14
Advertisement
Table of Contents
