Connecting With Other Equipment - Mitsubishi HS-7168E Installation And Operation Manual

CONNECTING WITH OTHER EQUIPMENT

CCTV
CAMERA
SET IN
SENSOR
VERTICAL ADJUSTMENT (Correcting picture vibration at the top and bottom)
The picture vibration can be reduced or eliminated by the following steps.
1 If the vibration occurs in still, slow motion, fast playback (x2) or normal playback in 24H - 168H or 0H mode, playback
a tape which is recorded in 3H or 6H mode with this VCR and press the PAUSE button.
If the vibration occurs during normal playback in L18H or L24H mode, playback a tape in each playback mode.
2 Press the VERTICAL ADJUST(+) or (-) button to reduce or eliminate the picture vibration.
• Connection with a CCTV monitor (for surveillance) is recommended.
• Connecting with some monitors may cause picture vibration and/or picture distortion at the top or bottom of the image
during still or normal playback.
A domestic Television Monitor may be unable to provide a stable picture without vibration and distortion.
MIC
MONITOR TO BE CONNECTED
VIDEO
OUT
VIDEO
IN
SET RST REC GND ALM MODE CLK CALL
IN
OUT
ÉMIC IN OUT
AUDIO IN OUT
VIDEO
MIC IN AUDIO
OUT
6
RESET
REMOTE
VIDEO
OUT
VIDEO IN
AUDIO IN
MONITOR