Maytag MGDE251YG0 Use & Care Manual page 9

wrinkle control eco normal wrinkle control
delicate heavy dut% delicate
damp dl
timed dry _ freshen u
refresh dry
Steam model Non-Steam model
_eavyduty
Settings and options shown in bold are default settings
for that cycle.
Not all features and cycles are available on all models.
Not all settings and options are available on each cycle.
Steam cycles (on some models) are designed for use
with dry loads to loosen wrinkles, reduce odors, and
refresh fabrics.
Adjusting drying time on Timed Cycles
When you select a Timed Cycle, the
default time appears in the display.
more ( )
Use the More Time/Less Time buttons
time
\J
to increase or decrease the time in
less _ 1 minute increments. Press and
time _,dJ
hold to change the time in 5 minute
increments.
The maximum dry time is 100 minutes.
Selecting the Drying Temperature
A High heat setting may be used for drying heavyweight
items such as towels and work clothes.
A Low to Medium heat setting may be used for drying
medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no heat (Air Dry) setting for foam, rubber, plastic,
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
Using Air Dry
Use the Air Dry temperature setting with Timed Cycles for items
that require drying without heat such as rubber, plastic, and
heat-sensitive fabrics. This chart shows examples of items that
can be dried using Air Dry.
Type of Load Est. Time*
(Minutes)
Foam rubber - pillows, padded bras, 20-30
stuffed toys
Plastic - shower curtains, tablecloths 20-30
Rubber-backed rugs 40-50
Olefin, polypropylene, sheer nylon 10-20
*Reset time to complete drying, if needed.
When using Air Dry:
. Check that coverings are securely stitched.
. Shake and fluff pillows by hand periodically during the cycle.
. Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Air Dry setting is only available with Timed Cycles.
iI __/i i iI__ _i_!i iV__i _ iii_
Items todry:
Any load
NOTE: Select Air
Dry to dry foam,
rubber, plastic,
or heat-sensitive
fabrics.
Small loads and
sportswear
D,'ving
Cycle: Temperature:
Timed Dry
Rapid Dry
(Non-Steam
models only)
High
Medium
Low
Extra Low
Air Dry
High
Medium
Low
Extra Low
Air Dry
Default
Time:
40
27
Options: ! .... Cycle Details:
I
Wrinkle Prevent_! _ Use to dry items to a damp level for items that do
i
not require an entire drying cycle. Select a drying
temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
Wrinkle Prevent
T M
_ For small loads of 3-4 items.
M.xo0,oa0s Fresheoop ..0h 20 Wr.ok.ePreventT Osetore0ocow
(Non-Steam Medium i_ the dryer too long. Cycle run time may be manually
models only) Low adjusted, and Temperature is selectable.
Extra Low
Air Dry
Shirts, blouses,
and slacks
Mixed Loads
Custom
Refresh
(Steam
models only)
Auto Refresh
(Steam
models only)
Medium
High
Medium
15
20
Wrinkle Prevent
TM
Wrinkle Prevent
TM
Q Use to reduce odors and light wrinkles. NOTE: Do not add dryer sheets.
Use to reduce wrinkles, including from loads left in
the dryer too long. Cycle run time may be manually
adjusted, and Temperature is selectable.
NOTE: Do not add dryer sheets.