USING THE POURING SHIELD*
Attaching
the Pouring ShieJd*
1. Make sure the speed control
lever is set to the OFF/Oposition.
2. Unplug the Stand Mixer or
disconnect power.
3. Attach desired accessory and
raise the mixing bowl.
4. Slide pouring shield collar
around beater shaft, centering
collar over rim of bowl.
Using the Pouring
ShieJd
Pour ingredients into the mixing
bowl through the chute portion of
shield.
Important:
Make sure the guides on
the bottom of the chute rest on the
rim of the bowl to keep ingredients
from falling outside the bowl as they
are added.
Pouring
Chute
/
Removing
the Pouring Shield
1. Make sure the speed control
lever is set to the OFF/Oposition.
2. Unplug the Stand Mixer or
disconnect power.
3. Removepouring chute
from collar.
4. Slide pouring shield collar
off bowl.
5. Lower the bowl support by
turning the bowl-lift lever
clockwise.
6. Remove accessory and the
mixing bowl.
CJeaning the Pouring
ShieJd
Wash in warm sudsy water. If you
wish you may place on the top rack
of your dishwasher.
* If Pouring Shield is included.