Ducting Information; Care Cleaning - Jenn-Air JDS9865BDP Use & Care Manual

Maytag dual-fuel modular downdraft slide-in range pro-style
Hide thumbs Also See for JDS9865BDP:
Table of Contents

Advertisement

Available languages

Available languages

Jenn-Air's
ventilation
system is designed to capture both
cooking fumes and smoke from the cooktop surface. If
the system does not, here are some ducting installation
situations to check:
• 6" diameter round or 3 114"x 10" rectangular
ducting
should be used for duct lengths 10'-60'.
Important:
5" diameter round ducting may be used if
the duct length is 10' or less.
• No more than three 90 ° elbows should be used.
Distance between elbows should be at least 18".
,, Recommended
Jenn-Air wall cap MUSTbe
used.
Make sure damper moves freely when ventilation
system is operating.
• There should be a minimum clearance of 6" for
cooktop
installed near a side wall.
If there is not an obvious improper
installation,
there
may be a concealed
problem such as a pinched joint,
obstruction
in the pipe, etc. Installation
is
the responsibility
of the installer and
questions
should be addressed first by the
installer. The installer should very carefully
check the ducting
installation
instructions.
Use the Flow Tester Card provided with
your appliance to check the air flow.
FLOW
TESTER
t
CARE
CLEANING
Self-Clea.
Ove.
Remove broiler pan, all pans, and oven racks from the
oven. The oven racks will discolor and may not slide easily
after a self-clean cycle if they are not removed. Important:
Remove the air grille from the cooking surface before self-
cleaning.
The self-clean cycle uses above-normal cooking temperatures
to automatically clean the oven interior.
Clean oven frame, door frame, area outside of gasket, and
around the opening in the door gasket with a nonabrasive
cleaner such as Bon Ami* or detergent and water. The
self-cleaning process does not clean these areas. They
should be cleaned to prevent soil
from baking on during the clean
cycle. O-he gasket is the seal
around the oven door and window.)
To prevent damage, do not clean
or rub the gasket around the oven
door. The gasket is designed to
seal in heat during the clean cycle.
The oven should be cleaned regularly by wiping up spillovers
to prevent excessive smoke and flare-ups. Do not allow a
heavy build-up of soil to accumulate in the oven.
5. Wipe up excess grease or spill-overs from the oven
bottom. This prevents excessive smoking, flare-ups or
flaming during the clean cycle.
During the cleaning process, the kitchen should be well
ventilated to get rid of normal odors associated with cleaning.
Before
Self-Cleaning
1. Turn off the oven light before cleaning. The oven light may
burn out during the clean cycle.
Wipe up sugary and acidic spillovers such as sweet
potatoes, tomato, or milk-based sauces. Porcelain enamel
is acid-resistant, not acid-proof. The porcelain finish may
discolor if acidic or sugary spills are not wiped up before a
self-clean cycle.
To set Self=Clean:
_.............,
( Clean
1. Press Clean pad.
,.................
2. REMOVE RACKS will be displayed. Remove the racks.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents