Install The Range; Level The Range; Final Installation Checklist - Hotpoint RA720 Owner's Manual & Installation Instructions

Installation Instructions
INSTALL THE RANGE
_] ANTI-TIP DEVICE INSTALLATION
Tip-Over Hazard
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back so the anti-tip arm slides under the anti-tip
bracket.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
To reduce the risk of tipping the range, the range
must be secured by a properly installed anti-tip
bracket. See installation instructions shipped with the
bracket for complete details before attempting to
install.
To check if the bracket is installed and engaged
properly, look underneath the range to see that the
anti-tip arm attached to the side panel is engaged
in the bracket. On some models, the storage drawer
or kick panel can be removed for easier inspection.
If visual inspection is not possible, slide the range
forward, confirm the anti-tip bracket is securely
attached to the floor or wall, and slide the range
back so the anti-tip arm slides just under the anti-tip
bracket. If the range is pulled from the wall for any
reason, always repeat this procedure to verify the
range is properly secured by the anti-tip bracket.
D
B]
LEVEL THE RANGE
For proper cooking and baking, the range must
be leveled. Leveling legs are located on each
corner at the base of the range.
Install the oven shelves (see
Using the oven section for
instructions). Put a spirit level
or a glass measuring cup
partially filled with water on
one of the oven shelves.
Turn the legs clockwise to
raise the range and
counterclockwise to lower
the range. Adjust the
leveling legs until the range
is level.
FINAL INSTALLATION CHECKLIST
, Check to make sure the circuit breaker is closed
(RESET) o r the circuit fuses are replaced.
@
@
Be sure power is in service to the building.
Check to be sure that all packing materials and
tape have been removed. This will include tape
on metal panel under control knobs (if applicable),
adhesive tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces have
heated.
Check to make sure that the Anti-Tip device is
securely installed.
Be sure all range controls are in the OFF position
before leaving the range.
21