Leveling The Range - Hotpoint RGB751GEL Use And Care Manual

grease
in the
broiler pan, turnoff
fire
oven, and keep oven door closed
to contain fire until it burns out.
Self-CleaningOven
. D
not
O
before reading special cleaning
instructions on page 19. The
door gasket is essential for a good
seal. Be cwful not to rub, damage
or move it.
commercial oven cleaner or oven
liner protective coating of any
kind should be used in or around
any part of the oven.
cookware
other
Wore self-
cleaning the oven.
parts listed in this
of accumulations of grease or
may ignite.
If You Need Service
or replace any part of your
range unless it is specifically
recommended in this book. All
other servicing should be referred
to a qualified technician.
INSTRUCTIONS
Flooring
under the Range
Your range, like many other
household items, is heavy and can
settle into soft floor coverings
such as cushioned vinyl or
carpeting. When moving the range
on this type of flooring, use care,
and it is recommended that these
simple and inexpensive instructions
be followed.
The range should be installed on a
l/4-inch-thick sheet of plywood (or
similar material) as follows: When
the floor covering ends at the front
of the range, the area that the range
will rest on should be built up with
plywood to the same level or higher
than the floor covering. This will
allow the range to be moved for
cleaning or servicing.
5

Leveling the Range

Leveling legs are located on each
comer of the base of the range.
Remove the bottom drawer and you
can level the range on an uneven
floor.
To remove drawer, pull drawer
out all the way, tilt up the front
and take it out. To replace drawer,
insert glides at back of drawer
beyond stop on range glides.
Lift drawer if necessary to insert
easily. Let front of drawer down,
then push into close.
One of the rear leveling legs
will engage the Anti-Tip bracket
(allow for some side to side
adjustment). Allow a minimum
clearance of 1/8" between the range
and the leveling leg that is to be
installed into the Anti-Tip bracket.