Power Cord And Strain Relief Installation - Hotpoint RA720 Owner's Manual & Installation Instructions

Installation Instructions
ELECTRICAL CONNECTIONS (CONT.)
POWER CORD AND STRAIN RELIEF
INSTALLATION
B3
B]
Remove the wire cover (on the lower back of
the range) by removing its top center screw.
Do not discard this screw.
Remove the knockout ring (isA<)located o n
bracket directly below the terminal block. To
remove the knockout, use a pair of pliers to
bend the knockout ring away from the bracket
and twist until ring is removed.
Knockout ring
in bracket
Terminal block
(appearance may
vary)
Knockout ring
removed
E1
For power cord installations only (see the
next step if using conduit), assemble the strain
relief in the hole. Insert the power cord
through the strain relief and tighten. Allow
enough slack to easily attach the cord
terminals to the terminal block. If tabs are
present at the end of the winged strain relief,
they can be removed for better fit.
NOTE: Do not install the power cord without
a strain relief. The strain relief bracket
should be installed before reinstalling the
rear range wiring cover,
Skip to Step 4 or 5.
Terminal
block
Strain relief
Power cord Bracket
El
For conduit installations only, purchase a
squeeze connector matching the diameter of
your conduit and assemble it in the hole. Insert
the conduit through the squeeze connector and
tighten. Allow enough slack to easily attach the
wires to the terminal block.
NOTE: Do not install the conduit without a
squeeze connector. The squeeze connector
should be installed before reinstalling the rear
range wiring cover.
Terminal
block
:1.8
Squeeze
connector
Conduit
\
Bracket
Skip to Step 6 or 7.