Table of Contents
Advertisement
Review this chart to find do-it-yourself solutions for minor performance problems, Any service
needed, other than those described in this owner's manual, should be performed by a Sears
authorized service representative,
WARNING
Electrical Shock Hazard
Disconnect electrical supply before servicing or cleaning the unit. Failure
to do so could result in electrical shock or personal injury.
Cleaner won't run.
PoorJobof dirt plck-up,
1, Unplugged at wail outlet
2. Tripped circuit breaker/blown fuse
at household service panel
3. On/off swilch not turned on
4
Thermal prolector tripped
1. Full or clogged dust bin
2. Wrong pile height setting
3. Clogged nozzle or dust bin port
4. Clogged hose
5. Hole in hose
6. Hose not inserted fully
7. Motor protection system aclivated
8. Dirty filters
1.
Plug In firmly, push on/elf
switch
to
on
2.
Reset circuit
breaker
or replace
fuse,
3. Push on/off switch to on
4
Reset thermal protector, (page 12)
1. Clean dust bin, (page 14-15)
2. Adjust setting, (page 7)
3. Check CLOG REMOVAL, (page 18)
4. Check for clogs, (page 15)
5o Replace hose
6. Insert hose fully, (page 5)
7_ Check for clogs, (page 15)
8. Clean/change fiiters, (page 16-17)
Cleaner picks up
t. Wrong pile height setting
1. Adjust selling, (page 7)
moveable rugs or
_ushes too hard.
Light won't work.
1. Burned out light bulb
1. Change light bulb, (page 17)
Agltator
does not turn,
1. Bare floor selector in bare
1. Move selector to lhe carpet setting,
floor setting
(page 7)
2. Handle in full upright position
2. Move handle from upright position
(page 8)
3. Agitator Ovedoad tripped
3. Reset Agitalor Overload (page 13)
4. Thermal protector tripped
4. Allow vacuum to cool, then reset
Thermal protector (page 13)
Aft flow restricted
1_ Attachment use restricts air flow
1. Check ATTACHMENTS, (page 8)
with attachment use.
2_ New carpet fuzz clogged air palh
2. Check CLOG REMOVAL and clean
Sound changes,
hose, (page 18),
19
Advertisement
Table of Contents
