Service; Before Calling Service; Troubleshooting Chart - Bosch HBL33 Use And Care Manual

Service
Before Calling Service
Troubleshooting Chart
Possible Causes and Suggested
Oven Problem
Solutions
Oven door is
locked and will
not open, even
after cooling.
Oven is not
heating.
Oven is not
cooking evenly.
Baking results
are not as
expected.
Food takes
Iongerto cook
than expected.
Foodis
overcooked.
Convection
Bake _sults are
not as expected
(some models).
Oven
temperature is
too hot or too
cold.
Turn the oven off at the circuit
breaker and wait five minutes. Turn
breaker back on. The oven should
reset itself and will be operable.
Check circuit breaker or fuse box to
your house. Make sure there is
proper electrical power to the oven.
Be sure oven temperature has been
selected.
Refer to cooking charts for
recommended rack position. Check
"Getting the Most Out of Your
Appliance" for tips and suggestions.
Refer to cooking charts for
recommended rack position. Check
"Getting the Most Out of Your
Appliance" for tips and suggestions.
Adjust oven calibration if necessary.
See "Oven Temperature Offset'
under "Customer Settings".
The oven is carefully calibrated to
provide accurate results. However,
the temperature can be offset if food
is consistently too brown or too light.
See "Oven Temperature Offset'
under "Customer Settings".
The oven is carefully calibrated to
provide accurate results. However,
the temperature can be offset if food
is consistently too brown or too light.
See "Oven Temperature Offset'
under "Customer Settings".
The oven temperature must be
manually reduced by 25 °F. Refer to
cooking charts and tips for rack
positions, cooking times and pan
selection. Adjust oven calibration if
necessary. See "Oven Temperature
Offset' under "Customer Settings".
The oven thermostat needs
adjustment. See "Oven Temperature
Offset' under "Customer Settings".
Possible Causes and Suggested
Oven Problem
Solutions
Oven light is not Replace or reinsert the light bulb if
working loose or defective. Touching the bulb
properly, with fingers may cause the bulb to
burn out.
Oven light does Check for obstruction in oven door.
not turn off. Check to see if hinge is bent.
Cannot remove There may be soil build-up around
lens cover on the lens cover. Wipe lens cover area
light, with a clean dry towel prior to
attempting to remove the lens cover.
Oven is not self-
cleaning
properly.
Clock and timer
are not working
properly.
"E" and a
number appears
in display and
control beeps.
With a new oven
there is a strong
odor when oven
is turned on.
Cont_ldoes not
_a_when a key
istouched.
Fanisrunning
during modes
thatdo notuse
convection
Warm air or
steam escapes
from oven vent.
Allow the oven to cool before
running self-clean. Always wipe out
loose soils or heavy spillovers before
running self-clean. If oven is badly
soiled, set oven for the maximum
self-clean time.
Make sure there is electrical power
to oven.
This is a fault code. Press any key or
turn knob to stop beeping. Reset
oven if necessary. If fault code
remains, record fault code, cancel
oven and call authorized service
technician.
This is normal with a new oven and
will disappear after a few uses.
Operating the self-clean cycle also
"burns-off" the smell more quickly.
Be sure that surface is clean and
dry. Touch the center of the touch
key. Use the flat part of your finger.
On some models, the convection fan
runs while the oven is preheating.
This is normal.
It is normal to see or feel steam or
warm air escaping from the oven
vent. Do not block the vent.
English 17