Amana AGDS902SS Owner's Manual page 17

4. Slide cartridge towards rear of range until cartridge
engages range. Lower front of cartridge into well.
5. Place burner caps on burner base.
C
A D
B/
_Burner Grate
B_urner Bowl
C Burner Cap
D Burner Base
Place Burner Caps and Grate
To make sure cap is properly aligned and leveled, move
burner cap around on burner base. Pegs in the burner
base fit into recess in underside of burner cap. Burner cap
must be correctly seated on burner base for proper
operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap is
placed on burner base.
Correct
Not centered Too small
Too large
Position Burner Caps
6. Ignite burner. Properly adjusted burner flames are
clean and blue with a distinct inner cone
approximately ½ inch long.
• If burnerflame is blowing or noisy, or if burner flame
is yellow and does not hold its shape, see
"Adjusting Burner Flame Characteristics" section.
7. Replace burner grate when flame is properly adjusted.
17