Table of Contents
Advertisement
Getting
started
You can enjoy high-quality
audio by connecting
the unit's audio output to your amplifier
or receiver.
Connect the unit's AUDIO OUT (FRONT LEFT/FRONT RIGHT) jacks to any line-level
inputs (such as AUX, DVD, CD, etc.) of
an audio amplifier
or receiver.
The unit
._White
Red _[
Audio cable (supplied)
Amplifier
or receiver
White
I .
Red
[-
NOTES
• When
using the
unit with
a stereo
amplifier
or receiver,
set
"ANALOG
OUT"
in the
"AUDIO"
preference
display
to "2-OH
STEREO"
(see page
65).
• If your stereo amplifier or receiver has an AV COMPU LINK terminal, you can use the AV COMPU LINK function. See "AV
COMPU LINK remote control
system"
on
page 75 for details
The unit supports the linear PCM multichannel
format
of DVD AUDIO and can feed multichannel
audio output signals
from the six analog AUDIO OUT jacks.
It is also equipped
with the DTS and Dolby digital decoders.
So you can enjoy any type of the high quality surround
sounds by connecting
the unit to an amplifier/receiver
equipped
with the 5.1-channel
inputs.
Connect the unit's analog AUDIO OUT jacks to the analog 5.1-channel
inputs of an amplifier
or receiver
using the
supplied
audio cables.
The unit
Amplifier
or receiver
l; ,udio video
I
cable
(supplied)
Yellow
Red
,J
White
Audio
cable
Red
(supplied)
White _
Audio cable
Red
(supplied)
FRONT
AUDIO IN
LEFT
RIGHT
REAR
LEFT
RIGHT
CENTER
SUBWOOFER
• Be sure to connect correctly
between corresponding
terminals.
The order of the 5.1-channel terminals
depend on units.
NOTE
• When
using the 5.1-channel
outputs
of the unit,
set the
"ANALOG
OUT"
in the "AUDIO"
preference
display
to "MULTI
CHANNEL" (see page 65). If you select "EXPERT" in the "SPK.SETTING" preference display,you can control the audio output
balance of the
speakers
(see page 66).
Advertisement
Table of Contents
