Table of Contents
Advertisement
In the following
description,
we assume that the buttons
on the remote control
unit are mainly
used, however,
you may
use the corresponding
buttons
on the front panel if available.
NOTE
Make sure that the TV - DVD switch on the remote control
unit is setto
"DVD"
when using the A/_'/
_/_
and numeric
buttons for controlling
the unit.
Before operation
Press DVD STANDBY/ON
_)/I on the remote control
unit or press STANDBY/ON
(b/I on the front panel.
When the unit turns on, the STANDBY/ON
indicator
on the front panel, which illuminates
in red during
standby, lights in
green and each DISC indicator
(1 to 7) shows the current status of whether
a disc is set or not in the corresponding
disc
tray.
C_3 C_3
C/.3
TV,
_V8
,W
cz_) _
cz3
5d _4
5d
DVD
STANDBY/ON
(.b/I
STA N D BY/O N
(b/I
STANDBY/ON
indicator
I _
_
5 '_' 5
'6 _
5
i i
i I
• The first time you turn on the unit after connecting
the power cord, the DISC 1 to 7 indicators
are illuminated
until the unit detects
that no disc is set in the corresponding
disc tray. Once detecting
the status, the unit memorizes
it unless you unplug the power
cord, so the DISC 1 to 7 indicators
show the status of corresponding
disc trays correctly.
• You can turn on the unit by pressing
the I_ button.
In this case, the behavior
of the unit after pressing
the I_ button
is the same as
pressing
this button
while the power is on.
• When any disc is on the disc tray, you can turn on the unit using the DISC 1 to 7 buttons corresponding
to the loaded disc number.
The behavior
of the unit after pressing
these buttons
is the same as pressing
them while the power is on.
• You can turn on the unit by pressing
the __ OPEN/CLOSE
button on the front panel. In this case, the disc tray carousel
opens.
The opening display shown right appears on the TV screen.
The following
message may appear at the bottom
of the opening
display
depending
on the condition.
• NOW READING:The
unit is reading the disc information.
• REGION CODE ERROR!:
The region code of the DVD VIDEO disc does not
match the unit. The disc cannot be played back.
• OPEN:
The disc tray carousel is opening.
• CLOSE:
The disc tray carousel is closing.
• NO DISC:
No disc is loaded.
• RESUME STOP:
The resume mode is set to "DISC RESUME."
Message
area
NOTE
• Even if you press DVD STANDBY/ON
_/I on the remote control unit or STANDBY/ON
_/I on the front panel to turn off the unit,
the unit is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called the
standby mode.
In this state, the unit consumes a very small amount of power.
14
Advertisement
Table of Contents
