Goldstar M1203R Owner's Manual page 11

SUGGESTED TOOL REQUIREMENTS
I SCREWDRIVER(+, -), RULLER, KNIFE, HAMMER, PENCIL,
LEVEL
PREPARATION OF CHASSIS
1. Remove the screws which fasten the cabinet
at both sides and at the back,_
2, Slide the unit from the cabinet by gripping the
base pan handle and pulling forward while
bracing the cabinet.
3. Remove EPS Material.
4. Cut the window sash seal to the proper length,
Peel off the backing and attach the foam-pe @
to the underside of the window sash,
5, Remove the backing from the top upper guide
Foam PE @ and a_ach it to the bottom of the
upper guide @,
6. Attach the upper guide onto the top of: the
cabinet with 3 type A screws,
7, insert the frame guides @ into the bottom of
the cabinet.
8. insert the Frame Curtain _') into the upper
guide @ and frame guides @.
9. Fasten the, curtains to the unit with 4 Type A
screws,
CABINET INSTALLATION
1. Open the window. Mark a line on center of the
window stool(or desired air conditioner
location).
Carefully place the cabinet on the window
stool and align the center mark on the bottom
front with the center line marked in the
window stool.
2. Pull the bottom window sash down behind the
upper guide until it meets.
"i
Do not pull the window sash down so tiglhtly
that the movement of Frame Curtain is
restricted.
(Type
Shipping screws
EPS Matedal
(Type A)
Upper Guide
_Window stool
Front Ang_,e Fig. 1
Foam-peQ
'_ Fig. 2
-11 -