Using Snmp For Print Server Management - Axis 5900 User Manual

Management and Configuration
Telnet Help

Using SNMP for Print Server Management

General Information
System Requirements
for SNMP
114
3. Restart the print server's protocols by typing:
softreset
Replace the command in step 3 above with
perform the other two reset operations.
By typing in step 3 in any of the Telnet instruction sets above, a list
help
of all available commands will be displayed.
You can use SNMP (Simple Network Management Protocol) for remotely
monitoring and configuring of the Axis Network Print Server. All major
functions for print servers are supported.
SNMP refers to a set of standards for network management, including a
protocol, a database structure specification, and a set of data objects. The
Axis Network Print Server SNMP implementation runs in the TCP/IP
environment.
The management is handled by NMS (Network Management System)
software running on a host on your network. The NMS software
communicates with network devices by the means of messages, which are
references to one or more objects.
A message can be a question or an instruction to a device, or an alarm
triggered by a specific event in a device. Objects are contained in data
bases called MIBs (Management Information Base), where MIB-II is a
standard database.
The Axis Network Print Server supports all relevant parts of MIB-II and
also includes a private enterprise MIB. Refer to The AXIS MIB, on page
115.
The following requirements must be fulfilled in order to make full use of
the Axis Network Print Server SNMP support:
• NMS software that allows you to install private enterprise MIBs
• A host, supporting FTP, on which to run the NMS software
Follow these steps to add the AXIS MIB to your NMS software:
1. Log in to the Axis Network Print Server using FTP.
2. Download the MIB file /snmp/axis.mib to the NMS host.
3. Install the AXIS MIB according to instructions in your NMS software
documentation.
to
or
hardreset default
AXIS 5900 User's Manual