GE JSP57 Owner's Manual page 6

Usingthe surface units.
NOTE: Throughout this manual, features and appearance may vary from your model
i!!! !iiiilili!iii!i! iiiiiiiiiii!ii iii iiiii i, !i!!i!i ii !iiiili; iii!!ii!i!iiii iiiii directionPUSh theknohinandtumineitherto the set.ng want.
i i; At both
OFF and HI the control clicks
indicatinginto clicking position, sounds the You control during may is h em" cooking, keeping slight the
power level you set.
A HOTSURFACE indicator light, on the
Be sure you turn the control knob to cooktop, will glow when any radiant
OFF when youfinishcooking, element is tin'ned on. It will remain
on until the suri_ace is cooled to
approximately 150°E
Hot surface indicator light will:
N comeon when the unit is hot to the touch.
_ stayon evenafter theunitis turnedell
_ glow untiltheunitis cooledtoapproximately
!50°£
The WARM setting on the right REAR
surface unit keeps ah'eady heated food
warm until ready to serve. Do not use to
heat cold food.
WARMING ZONE GUIDE
SETTING FOOD
1(Low) 8read/Pastries
2(Medium) Chocolate/%tter
2(Medium) Sauces, S tews,
CreamSoups
2(Medium) Vegetables
3(High) Soups (liquid)
3(High) Teaor Coffee
The Warming Zone Guideis for
reference only andthe SETi-ING
that you need will depend on the
amount and type of food, the
starting temperature of the food
and the length of the holding time.
Using the Warming Zone (onsomemodels)
The WARMING ZONE, located in the
center of the glass cooktop surface,
will keep hot, cooked food at serving
temperature. Always start with hot food.
Do not use to heat cold _bod. Placing
uncooked or cold food on the WARMING
ZONEcould result in food-borne illness.
[]
Touch the WARMINGZONE
SET'OFFpad.
[] Touch the number pads 1, 2 or 3
to select low (1), medium (2) or
high (3) warming setting.
[] Touch the STARTpad.
Always use pot holders or oven mitts
when removing
_bod from the WARMING
ZONE, since cookware and plates will be
hot.
It_ _IIIL#IW'II UT_ON; Do not warm food on the
WARMING ZONE for more than two hours.
NOTE: The warmingzone will not glow red like
the cooking elements.
ROTwill be displayed when the glass
surface is hot and will remain on until
the surf_ace is cool enough to touch.
NOTE: Lowersettings maynotheattheglass
surfaceenough to cause theHOT indicator light
to comeon.
To turn the WARMINGZONEoff, touch the
WARMING ZONESET'OFFpad until
WARMERdisappears from the display.
For best results, all foods on the
WARMINGZONE should be covered with a
lid or almninum fbil. When warming
pastries or breads, the cover should be
vented to allow moisture to escape.
A warming
zone ON light will glow when
the unit is on.
_ Donotuseplasticwraptocoverfood.Plastic
maymelt ontothesurface andbe verydifficult
to clean.
_ Useonlycookware recommended for
top-of-range c ooking
Using the Bridge Surface Unit
To use the bridge surt:ace unit. turn the
left front conwol
knob to the BRIDGE
settings.
For full bridge surface unit operation,
also turn on the left rear surface unit.
To use only the front sur_[_ace unit, turn
the conwol knob to the FRONTsetting_.