GE JSP57 Owner's Manual page 38

Before YouCall For Service...
Troubleshooting tips
Possible Causes What To Do
Plug on range is not completely * Make sure electrical plug is plugged into a live, properly
in_erted in the electrical outlet, grounded outlet.
A fuse in your home • Replace tile fuse or reset the circuit b_-eaken
may be blown or the
circuit breaker tripped.
Oven controls improperly set. • See the Using the clock and timer section.
The oven temperature is • :Mlow the range to cool and reset the controls.
too high to set a serf-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
The probe is plugged into • Remove the probe from the oven.
the outlet in the oven.
(on some models)
This is the sound of the • This is normal.
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil. • Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait undl the LOCKED light
goes off. Wipe tip the excess soil and reset the clean
cycle.
Oven too hot. • Allow the oven to cool below locking temperature.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to sell:clean
again or tot a longer period of time.
The self-dean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked • Touch the CLEAR/OFF pad. Allow the oven to cool.
because the temperature
inside the oven has not
droppodhelo the
locking temperature.
Yon have a function error code. • Touch the CLEAR/OFFpad. Put the oven back into
operation.
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect powel: If the function
error code repeats, call tbr service.
38