GE JSP57 Owner's Manual page 23

Usingthe self-cleaning oven. oom
The oven door must be closed and all controls set correctly for the cycle to work properly.
Before a Clean Cycle
We recommend venting your
kitchen with an open window or using a
ventilation fan or hood during the first
.- self:clean cycle.
Remove the racks, broiler pan, broiler
grid, probe, all cookware and any
aluminum foil from the oven.
Wipe up heavy soil on the oven
bottom,
The oven racks can be self-cleaned, but
they will darken, lose their luster and
become hard to slide.
Soil on tile front frame of the range and
outside tile gasket on tile door will need
to be cleaned by hand. Clean these areas
with hot w-ater, soap-filled steel-wool pads
or cleansers such as Soft Scrub? Rinse
well with clean water and dry.
material of tile oven door gasket cannot
withstand abrasion. It is essential for tile
gasket to remain intact, ffyou notice it
becoming worn or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is in
place and the oven light is off.
IMPORTANT."The health of some birds
is extremely sensitive to the fhmes given
off during the selfMeaning cycle of any
range. Move birds to another well-
ventilated room.
Do not clean the gasket. The fiberglass
How to Set the Oven for Cleaning
[] Touch the SELFCLEANLOiSTD pad
once for a 4-hour clean time or
twice for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when
cleaning small, contained spills. A
self-clean time of 4 hours or longer
is recommended for a dirtier oven.
Ifa time other than 4 hours or
3 hours is needed, um the number
pads and enter the desired clean
rime.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirvy your oven is.
[]
Touch the STARTpad.
The door locks automatically. The display
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKEDIight
goes off.
When the LOCKEDIight goes off, you will
be able to open the door.
N The word LOCKEDwill flash and the
oven control will signal if you set the
clean cycle and forget ro close the oven
dooi:
/}_5 To stop a clean cycle, touch the
CLEAR/OFFpad.When the LOCKED light
goes off indicating the oven has cooled
below the locking temperature, you
will be able to open the door.
23