GE JSP57 Owner's Manual page 39

ww_. GEAppliances.com
_ _ _ _ _ Possible Causes What To Do
You forgot to enter a . Touch the BAXE pad and desired temperature or
bake temperature or the SELF CLEAN LO/STD pad and desired clean rime.
_tatttim_ cleaning time.
A fuse in your home may be e Replace the fuse or reset the circuit bmakeE
blown or the circuit
breaker tripped.
The dock is in the • See the Special features of your oven control section.
black-out mode.
Power failure. • Reset the clock.
Oven control pads were • The BROIL HI/LO and BAKE pads must be touched at
not touched properly, the same time and held for 3 seconds.
This is reminding you to • Enter a probe temperature.
enter a probe temperature
after plugging in the probe.
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/0FF pad, setting the clock
and resetting any cooking fimction.
_trom_ve_
When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
oven section.
An odor from the insulation • This is tempera W.
around the inside of the oven
is normal for the first few times
the oven is used.
A cooling fan or a convection • This is normal. The cooling fan will turn offand on
fan (depending on the to cool internal parts. It may run after the oven is
function you are using) may turned OFF. The convection fhn will cycle on and off.
automatically turn on and off. until the function is over or the door is opened.
39