Table of Contents
Advertisement
3.5 MOTION DETECTION
MOTION SETUP MENU
CAMERA 1
MOTION
CAMERA 2
SENSITIVITY
CAMERA 3
CAMERA 4
DURATION
CAMERA 5
ALARM OUTPUT 01
CAMERA 6
E-MAIL
CAMERA 7
NETWORK
CAMERA 8
BUZZER
CAMERA 9
SUMMARY
MAIN MON
CALL MON
Menu display for EDR-910, EDR1610 identical, but with 16 cameras.
Define all motion detection settings for the individual cameras in the MOTION
DETECTION menu.
Use the JOG to select the cameras from the list on the left.
(1) MOTION:
ATTENTION: Motion detection is automatically deactivated upon opening an on-screen
display!
(2) SENSITIVITY:
Define the trigger sensitivity in 10 steps (1 – lowest, 10 – highest). Check the setting by
carrying out a moving test within the zone setting.
(3) DURATION:
Alarm duration upon motion detection. Duration applies to recording, screen change,
buzzer and output contact and is adjustable from 1~99 seconds.
(4) ALARM OUTPUT: Output relay activation.
COPY function
Motion detection settings can be copied from one camera to another. The zone settings
cannot be copied.
Select the camera to be copied from the camera list on the left and press the COPY key.
The message "COPIED" appears at the top screen margin. Select the camera which shall
apply the settings from the camera list. Press the SEARCH key to assign the copied
settings to the camera. The message "PASTED" appears at the top screen margin.
ENABLE
07
05 SEC
NO
NO
DISABLE
NO CHANGE
NO CHANGE
ENABLE:
DISABLE:
1 :
NONE:
- 33 -
Motion detection is activated.
Motion detection is deactivated.
Output relay 1 is switched in
case of motion detection.
Output relay is deactivated.
EDR910_1610_ma_en_rev1 00
Advertisement
Table of Contents
