Network Setup - Panasonic TH-65VX300U Operating Instructions Manual

Network Setup

Make the various settings to use the network function.
SCREENSAVER
EXTENDED LIFE SETTINGS
INPUT LABEL
FUNCTION BUTTON SETTINGS
ON/OFF TIMER SETUP
DAY/TIME SETUP
NETWORK SETUP
COMPONENT/RGB-IN SELECT
NETWORK SETUP
SAVE
DHCP
IP ADDRESS
SUBNET MASK
GATEWAY
PORT
LAN SPEED
NETWORK ID
CONTROL I/F SELECT
MAC ADDRESS
SAVE
Save the current network Setup. Each value set for DHCP,
IP address, Subnet mask, and Gateway will be saved. If
"NG" is displayed, check the same IP address is not used
within the same network.
DHCP (DHCP client function)
To obtain an IP address automatically using a DHCP server,
set this to "ON". If DHCP server is not used, set this to
"OFF".
IP ADDRESS (IP address display and setting)
Enter an IP address if DHCP server is not used.
SUBNET MASK (Subnet mask display and setting)
Enter a subnet mask if DHCP server is not used.
GATEWAY (Gateway address display and setting)
Enter a gateway address if DHCP server is not used.
Notes:
• To use a DHCP server, make sure the DHCP server is started.
• Contact your network administrator for details on settings.
DHCP, IP ADDRESS, SUBNET MASK, and GATEWAY settings
1
Set DHCP.
When "OFF" is selected, IP ADDRESS and other settings can be set manually.
2
Select the item and press
3
Enter an address.
RGB
IP ADDRESS
access
2
select
1
4
Select "SAVE" and press
OFF
192.168. 0. 8
PORT setting
255.255.255. 0 1
Select "PORT" and press
192.168. 0. 1
2
Enter a port number.
PORT
1024
AUTO
0
RS-232C
--:--:--:--:--:--
Use
1
I 192.168. 0. 8
2 Use
numerical value from
Press
3
Pressing
Use
1
I
01024
2 Use
numerical value from
Press
3
Pressing
PORT
Set the port number used for command control.
The available setting range is 1024 – 65535.
When the PJLink™ protocol is used, the port setting is not
necessary.
LAN SPEED
Set the connection speed of the LAN environment.
Select the value from AUTO, 10 HALF, 10 FULL, 100 HALF
or 100 FULL.
NETWORK ID
Set the ID to identify this unit.
The available setting range is 0 – 99.
CONTROL I/F SELECT
Set whether to control with RS-232C (serial) or LAN. When
"LAN" is set, power is supplied to LAN circuit, and power
indicator is lit orange under the condition of power off with
remote control (stand-by state).
MAC ADDRESS
Display the MAC address of this unit. However, the MAC
address is not displayed when the "CONTROL I/F SELECT"
is set to "RS-232C".
SETUP menu
.
to select a digit.
to change a number or input the
to
.
will cancel the address change.
.
.
to select a digit.
to change a number or input the
to
.
will cancel the port number change.
.
.
59