Signal Menu - Panasonic TH-65VX300U Operating Instructions Manual

SETUP menu

SIGNAL menu

Note:
"SIGNAL" setup menu displays a different setting condition for each input signal.
3D SETTINGS
SIGNAL
WAVEFORM MONITOR
MARKER SETTINGS
RGB/MONO SETTINGS
SCREENSAVER
EXTENDED LIFE SETTINGS
INPUT LABEL
FUNCTION BUTTON SETTINGS
ON/OFF TIMER SETUP
DAY/TIME SETUP
NETWORK SETUP
COMPONENT/RGB-IN SELECT
RGB
EXTERNAL SCALER MODE OFF
POWER SAVE OFF
Input signal display
Displays the frequency
and the type of the current input signal.
This display is valid only for
COMPONENT/RGB/PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during DVI signal input.
• 3D Y/C FILTER (NTSC)
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Set this menu when the moving image looks unnatural during Video (S Video) input signal.
ON OFF
Note:
When ON, this setting only affects NTSC input signals.
• COLOR SYSTEM
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
AUTO PAL
Set the color system to match the input signal. When "AUTO" is set, COLOR SYSTEM will be automatically selected
from NTSC/PAL/SECAM/M.NTSC.
To display PAL60 signal, select "AUTO" or "PAL".
If the image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become
unstable. Should this occur, set the system to match the format of the input signal.
• XGA MODE
This menu is displayed when the input signal is analog (Component/PC).
This unit supports three types of XGA signals with 60Hz vertical frequency having different aspect ratios and sampling
rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
AUTO 1024×768
AUTO: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view or display resolution condition.
Note:
After making this setting, be sure to make each adjustment (such as "AUTO SETUP") on the "POS. /SIZE" menu as
necessary. (see page 25)
46
access
2
select
1
SECAM M.NTSC
1280×768 1366×768
Select the item and set.
For VIDEO (S VIDEO)
SIGNAL
3D Y/C FILTER (NTSC)
COLOR SYSTEM AUTO
For COMPONENT
[ COMPONENT ]
SIGNAL
FRAME CREATION MID
XGA MODE AUTO
H-FREQ. 33.7 kHz
V-FREQ. 60.0 Hz
SIGNAL FORMAT 1125(1080)/60i
NTSC
For RGB
[ VIDEO ]
SIGNAL
ON SYNC
XGA MODE
H-FREQ.
V-FREQ.
SIGNAL FORMAT
For Digital
(Example: DVI input)
SIGNAL
FRAME CRATION
H-FREQ.
V-FREQ.
DOT CLOCK-FREQ.
SIGNAL FORMAT
change
2
select
1
[ RGB ]
AUTO
1024 ×768
33.7 kHz
60.0 Hz
1125(1080)/60i
[ Digital ]
MID
33.7 kHz
60.0 Hz
108.0 MHz
1125(1080)/60i