Parts Identification - Mitsubishi Electric Melservo-J2-JR SERIES Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.5 Parts Identification

Name/Application
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter operations.
MODE UP DOWN
I/O signal connector (CN1A)
Used to connect digital I/O signals.
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Name plate
Servo motor connector (CNP2)
Connector for connection of the servo motor.
Power input connector (CNP1)
Used to connect the input power supply/control circuit
power supply/RS-422.
Communication connector (CNP3)
Used for connection with a personal computer
(RS-232C).
Earth (E) terminal ( )
To conform to the EN Standard, fit the supplied earth
terminal for grounding.
1 - 4
SET
Used to set parameter
data.
Used to change the
display or data in each
mode.
Used to change the
mode.
Refer To
Chapter6
Chapter6
Section3.3
Section3.3
Section1.3
Section3.3
Section10.2.1
Section12.1.1
Section3.3
Section10.2.1
Section3.3
Section10.2.1
Section12.1.3
Section3.9