Parts Identification - Mitsubishi Electric MELSERVO-J3W Series Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.7 Parts identification

SW1 ON 4E
TEST
SW2
Side view
Bottom
8
1 2
Name/Application
Display
The 3-digit, seven-segment LED shows the servo status
and alarm number.
Rotary axis setting switch (SW1)
SW1
Used to set the axis No. of servo amplifier.
8
Test operation select switch (SW2-1)
SW2
Used to perform the test operation
mode by using MR Configurator.
For manufacturer setting (Be sure to set
1 2
to the "Down" position).
Charge lamp
Lit to indicate that the main circuit is charged. While this
lamp is lit, do not reconnect the cables.
Main circuit power supply connector (CNP1)
Connect the input power supply.
USB communication connector (CN5)
Connect the personal computer.
I/O signal connector (CN3)
Used to connect digital I/O signals.
More over an analog monitor is output.
Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative
option.
SSCNET cable connector (CN1A)
Used to connect the servo system controller or the front
axis servo amplifier.
A-axis servo motor power output connector (CNP3A)
Connect the A-axis servo motor.
SSCNET cable connector (CN1B)
Used to connect the rear axis servo amplifier. For the final
axis, puts a cap.
A-axis servo motor encoder connector (CN2A)
Used to connect the A-axis servo motor encoder.
B-axis servo motor encoder connector (CN2B)
Used to connect the B-axis servo motor encoder.
Battery connector (CN4)
Used to connect the battery for absolute position data
backup. Battery is not required in fully closed control.
B-axis servo motor power output connector (CNP3B)
Connect the B-axis servo motor.
Protective earth (PE) terminal (
Ground terminal.
Rating plate
Servo motor selection switch (SW3)
Used to select the servo motor to
be used.
A-axis
OFF: Rotary servo motor
B-axis ON : Linear servo motor and
1 - 8
)
direct drive motor
Detailed
explanation
Section 4.3
Section 3.13
Section 3.1
Section 3.3
Section 11.4
Section 3.2
Section 3.4
Section 3.1
Section 3.3
Section 3.9
Section 3.1
Section 3.3
Section 3.9
Section 3.4
Section 11.1
Section 11.3
Chapter 12
Section 3.1
Section 3.3
Section 1.5
Section 3.14