Table of Contents
Advertisement
•
Keep cutting
pressure
constant.
Do not overload the motor.
•
Use only sharp cutting
bits that are not chipped
or cracked.
Blunt cutting
bits will cause stalling and burn the workpiece.
•
Never
use this router motor with a cutting
bit larger than 1-1/2 inch in
diameter.
Always
use cutting
bits that are designed
for this router. Never use cutting
bits that are larger in diameter than the opening
in the router sub-base.
Cutting
bits that have cutting
diameters
larger than the opening
could cause
possible
loss of control or create other hazardous
conditions
that could
cause serious personal
injury.
Do not use large router cutting
bits for freehand
routing. Using large cutting
bits for freehand
routing could cause loss of control or create hazardous
conditions
that could result in serious personal injury. If using a router table,
large bits should be used for edging only.
Do not remove more than 1/8-inch
of material in a single pass. Excessive
depth of cut can result in loss of control that could result in personal injury.
Turn the motor
OFF after completing
a cut, and let the motor come to a
complete
stop before removing the router from the workpiece.
Allow the motor come to a complete stop before putting the router down.
Cutting bits coast after the power is turned off.
Disconnect the tool from the power source before making any adjustments
or changing cutting bits.
Do not touch
the collet/nut
or cutting
bit with your hands or fingers if you
are changing
a bit immediately
after use. The heat buildup from cutting could
cause severe burns. Always use the wrench provided.
•
Avoid "climb
cutting".
See "OPERATION"
(pages 16-29) section in this
manual.
"Climb-cutting"
increases
the chance for loss of control resulting in
possible
serious injury.
_,
WARNING:
Use of this product can generate
dust containing
chemicals
known to the state of California to cause cancer, birth defects or other
reproductive
harm. Some examples
of these chemicals
are:
•
Lead from lead-based
paints.
•
Crystalline
silica from bricks and cement and other masonry
products.
•
Arsenic and chromium,
from chemically
treated lumber.
Your risk from these exposures
varies, depending
upon how often you do this
type of work. To reduce your exposure
to these chemicals:
•
Work in a well-ventilated
area.
•
Work with approved
safety equipment,
such as those dust masks that are
specially
designed
to filter out microscopic
particles.
28212
Manual_Revised_07-0713
Page 9
Advertisement
Table of Contents
