Programming; Add Additional Hand-Held Remote Control; To Erase All Codes; 3-Function Remotes Controls - Craftsman 139.53964SRT Owner's Manual

PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+ remote controls.
To Add an Additional Hand-held Remote Control
USING THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed, two clicks will be
heard.
1,
2,
3,
4,
Press and hold the button on the
hand-held remote* that you wish
to operate your garage door.
While holding the remote button,
press and hold the LIGHT button
on the Premium Control Console.
Continue holding both buttons
while you press the push bar on
the Premium Control Console
(all three buttons are held).
Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not
installed, two clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, []
first erase all codes:
Press and hold the 'learn" button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.
*3.Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any Security+
3-function remote or .,,,,,_,_C-C-__ s/_
compact remote can be
programmed to operate
other Security+ garage
door openers.
35