Craftsman 320.27680 Operator's Manual page 35

TO ADJUST DEPTH WITH DEPTH-ADJUSTMENT WRENCH
(Figs. 28, 28a and 28b)
NOTICE: The Depth-Adjustment wrench
supplied is used to adjust the depth when Fig. 28
the router is fixed to the router table (Model
No. 320. 28160), sold separately.
WARNING: Always read and follow all
directions for mounting the router to a router
table and for use of the router table.
A_, WARNING: Always turn the router motor
off and unplug the router from the power
source before making any adjustments or
installing accessories. Failure to turn the
router motor off and unplug the router could
result in accidental starting, which can cause
serious personal injury.
_, WARNING: Only use router tables with
proper guarding for the cutting bit and with
"on-board," switch-controlled receptacles.
Failure to use router tables with appropriate
safety features could result in serious
personal injury.
Fixed Base Router
When using the fixed base to attach the
router to the router table, the bit depth can
be adjusted by turning the Micro-adjustment
Dial clockwise or counterclockwise with the
wrench supplied (Figs. 28 and 28a). The
depth of the cut can be read on the scale
dial.
Each mark on the scale indicates a 1/64 in.
change in depth setting.
1. Turn off the router.
2. Loosen the router motor clamp.
3. Insert the wrench into the adjusting hole on the tabletop. Turn the adjustment
bolt on the router clockwise with the wrench to move the collet/nut up, or
counterclockwise to move the collet/nut down.
4. When the desired depth of cut is set, tighten the router motor clamp. The
precise depth of cut can be measured with a ruler.
Plunge Base Router
When using the plunge base to attach the router to the router table, the bit depth
can be adjusted by turning the depth rod clockwise or counterclockwise with the
wrench supplied (Fig. 28b).
27683 Manual_Revised_11-0120 Page 35