Craftsman 320.27680 Operator's Manual page 25

To attach the edge guide to the fixed or
plunge base, simply insert the edge guide
rods into the edge-guide mounting slots
either from the left or the right.
For fix base Tighten the lever on the left
by turning it clockwise to secure the edge
guide rod (Fig.14). Tighten the lever on right
by turning counterclockwise to secure the
rod (Fig.14).
For plunge base Tighten the lever on the left
by turning it counterclockwise to secure the
edge guide rod (Fig.14a). Tighten the lever on
right by turning clockwise to secure the rod
(Fig.14a)
NOTICE: If the edge guide lever inner screws
wear down or require calibration:
• Pull the lever up and turn it clockwise and
then push the lever down (Fig.15).
Turn the lever counterclockwise to secure
the edge guide.
ELECTRONIC VARIABLE SPEED
CONTROL (Fig. 16)
The electronic speed control feature allows
motor speed to be matched to cutter size and
material for an improved finish and extended
bit life.
Fig. 14
Fig. 15
Speed changes are made starting at "1",
rotating the speed control dial to the "LEFT"
to increase the speed, from 1 through 9.
NOTICE: The speed may be changed while
the router is "ON", but not if the cutter bit is in
the workpiece.
Your router motor top cap has a "Variable
Speed Selection Chart," located above
the "ON/OFF" toggle switch, to help you
determine the correct speed for the cutter bit
being used.
WARNING: Before operating your router, follow all safety instructions in this
manual. Failure to do so could result in serious personal injury.
NOTICE: Choose the applicable cutting speed according the bit diameter and
the material being cut.
27683 ManuaLRevised_11-0120 Page 25