Craftsman 320.27680 Operator's Manual page 19

2.
3.
7. After all adjustments are made, close the motor clamp securely.
To install the Motor in Plunge Base (Fig. 5a)
1. Turn the motor off and unplug the
Fig. 5a
router from the power source.
Place the plunge base on a
fiat surface.
4.
With the back of router facing you,
open the motor clamp (A) and make
sure that the plunge action is in the
"UP" position with the plunge lock
lever (B) locked.
With the motor housing slot (C)
aligned with the plunge base pin
(D), lower the motor housing into
the plunge base, engaging the pin
into the slot.
B
5. Slide the motor into the base as far as it will go.
6. Close the motor clamp securely.
REMOVING THE MOTOR FROM THE BASES
To remove the Motor from the Fixed Base (Fig. 5)
A_, WARNING: Always turn the motor off and unplug the router from the power
source before making any adjustments or installing accessories. Failure to turn
the motor off and unplug the router could result in accidental starting, which can
cause serious personal injury.
1. Turn the motor off and unplug the router from the power source.
2. Place the router (fixed base and motor housing) on a fiat surface.
3. With the back of the router facing you, open the motor clamp (A).
4. Push in the coarse adjustment knob (B) to release the router motor housing
"slot" (C) from the pin (D) in the base, while you lift motor free of base.
5. Set the motor upside down on its top cap with the collet/nut pointing up and
remove the cutter bit.
_, WARNING: Always remove the cutter bit from collet/nut when the router is
not being used. Leaving bits installed could result in accidents causing serious
personal injury.
To Remove the Motor from the Plunge Base (Fig. 5a}
1. Turn the motor off and unplug the router from the power source.
2. Place the router (plunge base and motor housing) on a flat surface.
3. With the back of the plunge base facing you, open the motor clamp (A) and
make sure that the plunge action is in the "UP" position, with the plunge lock
lever (B) locked down.
27683 ManuaLRevised_11-0120 Page 19