Unpacking The 703T Server - Nortel CALLPILOT Installation And Configuration Manual

November 2005

Unpacking the 703t server

Introduction
Follow this procedure to unpack the server and peripherals.
.
To unpack the equipment
ATTENTION
1 Carefully open the cardboard carton containing the server.
2 Remove the server from the carton and set it on the floor.
3 Carefully open the cartons containing the monitor, keyboard, mouse,
modem, and ELAN hub (if supplied), and set the peripherals aside.
4 Put all manuals, CD-ROMs, operating system disks, any disks for
peripherals, and the Windows NT emergency repair disk in a safe place.
Part 2: 703t Server Hardware Installation
WARNING
Risk of personal injury
The 703t CallPilot server weighs approximately 22 kg (46 lb)
as shipped from manufacturing. If necessary, and to prevent
personal injury, ask someone to help you unpack and position
the server.
As you unpack each item, check it off against the
packing list, as well as against the following checklists
provided in CallPilot Installation and Configuration
Part 1: Installation and Maintenance Overview (555-
7101-210):
"CallPilot software media and documentation
checklist"
"CallPilot server hardware checklist"
Preinstallation requirements
35