Assembly - Craftsman 137.212371 Operator's Manual

Estimated Assembly Time: 5-10
minutes
,_WARNING
To avoid injury, do not connect
this miter saw to the power source
until it is completely assembled and
adjusted and you have read and
understood this Operator's Manual.
INSTALLING THE MITER HANDLE
(FIG. A)
1. Thread the miter handle (1) into the
hole located at the front of the miter
table.
Fig. A
UNLOCKING THE SLIDE CARRIAGE
(FIG. B)
The slide carriage lock knob (1) is
located on the right side of the slide
carriage. Loosen the slide carriage lock
knob (1) to unlock the slide carriage.
When transporting or storing the miter
saw, the slide carriage should always
be locked in position.
SAW BLADE WRENCH (FIG. C)
1. For convenient storage and
prevention of loss, there is a slot (1)
in the rear of the carrying handle
(2) for storing the blade wrench (3)
when not in use.
Fig. C
2
CUTTING HEAD (FIG. D)
Raising
1. Push down slightly on the switch
handle(I).
2. Pull out the stop latch knob (2).
3. Allow the cutting head to rise to the
up position.
_WARNJNG
To avoid injury and damage to the
saw, transport and store the miter
saw with the cutting head locked
in the down position. Never use
the stop latch to hold the cutting
head in a down position for cutting
operations.
Fig. B Fig. D