Craftsman 137.212371 Operator's Manual page 9

20.MAKE SURE thebladehascome
toa complete s topbeforeremoving
or securing theworkpiece, changing
theworkpiece a ngleor changing t he
angleoftheblade.
21
.NEVER cut metals or masonry
products with this tool. This miter
saw is designed for use on wood
and wood-like products'i
22.NEVER cut small pieces. If the--:
workpiece being cut would cause
your hand or fingers to be within
7-1/2 in. of the saw blade, !he_
workpiece is too small.
23.PROVIDE adequate Support to
the sides of the saw table for long
workpieces.
24.NEVER use the miter saw in areas
with flammable liquids or gases.
25.NEVER use solvents to clean plastic
parts. Solvents could possibly
dissolve or otherwise damage the
material.
26.SHUT OFF the power before
servicing or adjusting the tool.
27.DISCONNECT the saw from
the power source and clean the
machine when finished using .....
28J_IAKE SURE the work area is clean
before leaving the machine.
29.SHOULD any part of you[ miter
saw become missing, damaged,
fail in any way or any electrical
_component fail to perform properly,
shut off the switch and remove the
plug from the power supply outlet.
Replace missing, damaged or failed _
parts before resuming operation.