HP Surestore Disk Array 12h - And FC60 Service Manual page 131

Error Message
Ready No errors or warnings to report; the array is
ready to transfer data.
Rebuild The command to Rebuild did not start.
Not Started
Rebuild The SCSI command to Rebuild did not stop.
Not Stopped
Recover Failed Data was not fully recovered during the recover
utility.
Recover Warning Problem occurred while using the recover utility. The array is malfunctioning.
Rebuild A front panel request to begin a rebuild
Requested occurred.
Shutdown The controller has posted the NVRAM to the
Complete disks and the array is ready to be turned off.
Shutting Down The controller is preparing to enter the
Shutdown state.
SIMM 1/2 x/y SIMM 1 or 2 on controller module X or Y failed. Replace the controller.
Failed
SIMM The controller modules each have a different
Count Error number of SIMMs installed. You must have the
same amount of memory on both controller
modules.
SIMM Error The primary controller does not have enough
SIMMs to upload the present disk volume set.
Single Controller Resiliency parameters are not set to single
controller mode but the array has a single
controller installed.
Explanation
Control Panel Error Messages
Action
None. Information only.
The array is malfunctioning.
Call the support line.
The array is malfunctioning.
Call the support line.
The array is malfunctioning.
Call the support line.
Call the support line.
None. Information only.
None. Information only.
None. Information only.
Add or remove SIMMs from the NEW
controller module so that each controller has
the same amount of memory. DO NOT remove
any SIMMs from the original single controller
module; you must always have the same
amount of memory (or more) on each
controller module as you had on the original
single controller module.
Add more SIMMs to the controller module(s).
Each controller must have the same amount of
memory.
Either put the disk array in single controller
mode or install a second array controller.
Troubleshooting
131