HP Surestore 125ex - Optical Jukebox Manual page 53

3
3
O
PERATING THE
The security code 0 0 0 is set at the factory. This code is used when accessing and setting jukebox configurations.
Consider changing the security code so that only authorized persons can change the configurations.
NOTE:
Start with READY or SECURE in the display.
NEXT
1. Press
2. Press
PREVIOUS
3. Press
NOTE:
JUMP 4. Press
5. Press
CONTENTS 6. Press
7. Press
INDEX
8. Press
9. Press
10. Press
NOTE:
J
UKEBOX
Don't forget your security code. If you forget it, only your service representative can reset the security code to the factory
setting so you can set a new code.
until CONF * displays
NEXT
ENTER . CONF 0 and a flashing 0 displays.
NEXT until CONF 17 displays.
Starting from when you press ENTER
ENTER . CODE 1 and a flashing 0 displays.
NEXT until the first number of your current security code displays.
. CODE 2 and a flashing 0 displays.
ENTER
until the second number of your current security code displays.
NEXT
. CODE 3 and a flashing 0 displays.
ENTER
until the third number of your current security code displays.
NEXT
.
ENTER
If you entered an incorrect code, NO CONFIG displays briefly and then CONF 17 displays. Repeat steps 4-10 again and
enter the correct current code.
in the next step, you are prompted to enter the current security code.
14