HP Surestore 125ex - Optical Jukebox Manual page 22

1
1
S
ETTING UP THE
C
ONNECTING THE
The default IDs for the jukebox are as follows. Check to see if there will be any conflicts in this installation.
Autochanger (jukebox robotics) = 3
Drive 1 = 4
NEXT
Drive 2 = 5 (if installed)
NOTE:
PREVIOUS
JUMP
1. Ensure that the mailslot shipping bracket and the shipping screw are removed.
CONTENTS
NOTE:
2. Ensure that your host computer is OFF and the jukebox standby/on switch is in the STANDBY position.
INDEX
The jukebox standby/on switch is in STANDBY when the STANDBY side of the switch is depressed. The switch is
shown by "2" on
J
UKEBOX
If any of the autochanger/drive IDs are already being used, you can either change IDs used by the host bus adapter or
another device on the bus, or you can change the autochanger/drive IDs.
If you choose to change the IDs of devices other than the autochanger and/or drives, do it now (before you begin
cabling). Refer to your host and host bus adapter documentation.
If you will be changing the IDs of the autochanger or the drives, you will be given an opportunity to do this in the
installation steps that follow.
If you will be changing SCSI IDs in the host, finish changing them before doing the next step. See the previous NOTE.
Figure 1-1.
J
UKEBOX AS THE
O P
NLY ERIPHERAL
11