HP Surestore 125ex - Optical Jukebox Manual page 29

1
1
S
ETTING UP THE
M
OVING OR
To move the jukebox a short distance, such as to another office or to another floor in your building, refer to
Jukebox a Short
M
OVING THE
NEXT
1. Unmount any optical disk surfaces in the jukebox if necessary.
See your computer operating system, or software application documentation for instructions on how to unmount
PREVIOUS
optical disks.
2. Ensure that there are no disks in the drives.
JUMP
Eject any disks as necessary. Refer to your jukebox application software documentation. If you will be manually
ejecting disks, refer to
Caution:
CONTENTS
Caution:
INDEX
3. Switch the jukebox standby/on switch to STANDBY (see "2" on
4. Remove the power cord from the wall/floor receptacle and the SCSI cable connections from the rear of the jukebox.
5. Carefully move the jukebox to its new destination. If the jukebox contains disks, do not tip the jukebox or lay it on
its side.
J
UKEBOX
S
HIPPING THE
Distance". To ship the jukebox to another location, refer to
J
UKEBOX A
"Ejecting a Disk Cartridge From the Jukebox" on page
Failure to eject a disk from the optical drive prior to moving the jukebox could result in damage to the optical drive mechanism.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive. Removing power from a SCSI peripheral when
the bus is active can result in data loss and/or indeterminate bus states. Check your host system manuals for information about
checking the SCSI bus status.
If your computer is connected to a LAN, ensure that other users on the LAN are not accessing the jukebox.
J
UKEBOX
"Shipping the
S D
HORT ISTANCE
Figure 1-1).
"Moving the
Jukebox".
3-11.
18