HP Surestore 125ex - Optical Jukebox Manual page 31

1
1
S
ETTING UP THE
The disk transport mechanism will lower to the chassis when power is turned off. The position at the bottom of the
chassis is correct for insertion of the shipping screw (inserted in Step 6).
4. Remove the power cord from the wall/floor receptacle and the SCSI cable from the jukebox rear panel (see "1" and
"3" on
5. Secure the mailslot by inserting the mailslot shipping bracket. Refer to
NEXT
The shipping bracket slides into the mailslot easily, but will not latch. Place a piece of tape across the bracket to
keep it in place.
PREVIOUS
6. Re-insert the shipping screw that was removed when the jukebox was unpacked. This screw is 6/32 UNC-2B cap
screw 1 3/4 inches long. Re-install in the position shown in
and may be ordered from HP DIRECT.
JUMP
7. Repack the jukebox in its original shipping carton.
An alternative method of shipping is careful packaging and padded van shipping.
CONTENTS
INDEX
J
UKEBOX
Figure 1-1).
page 6 for a description of this bracket.
Figure 1-3. This screw is HP part number 2360-0551
20