Panasonic Lumix DMC-ZS10 Owner's Manual page 62

Troubleshooting
L=J""I "' "" [' I 11' I' I ', ,, i .... II I '
Camera does not work even if power is turned on.
e Battery is not inserted correctly (--,12), or needs recharging.
LCD monitor shuts off even if power is turned on.
[Sleep Mode] is activated. (-->45)
-_ Press shutter button halfway to release.
o Battery needs recharging.
Camera switches off as soon as power is turned on.
e Battery needs recharging.
@[Sleep Mode] is activated. (-+45)
Press shutter button halfway to release.
This unit is turned off automatically.
e If you connect to a TV compatible with VIERA Link with an HDMI mini cable (optional) and turn off
the power on the TV with the remote control for the TV, the power on this unit also turns off.
If you are not using VIERA Link, set [VIERA Link] to [OFF]. (_47)
Cannot perform positioning.
@When [GPS Setting] is set to [OFF], (-->76)
@Depending on the recording environment, such as when indoors or near buildings, it may not be
possible to correctly receive the signals from the GPS satellite& (--_75)
When using the GPS, we recommend holding the camera still for a while with the GPS antenna
facing upward in an outdoor location where you can see the entire sky.
The GPS status indicator lights up while the camera's power is off.
[GPS Setting] is [ON].
-, When turning off the camera's power in an airplane, hospital or other restricted area, set [GPS
Setting] to [OFF] or _'_'0es.
Positioning takes time.
@When using the camera for the first time or after not using it for a while, positioning may take several
minutes.
Positioning usually takes less than two minutes, but because the positions of the GPS satellites
change, it may take longer depending on the recording location and environment.
Positioning will take time in environments where it is difficult to receive the signals from the GPS
satellites. (-->75)
The location name information is different from the recording location.
Immediately after the camera's power is turned on or when the GPS icon is something other than
_, the location name information that is recorded in the camera may vary significantly from the
current position.
When _ is displayed for the location name information, the information can be changed to a
different candidate before starting to record. (-->79)
The location name information is not displayed.
® "- - -" is displayed if there is no nearby landmark or other points, or no information registered in the
camera's database. (_77)
--> During playback, a location name or othe_ information can be entered with [Place-Name Edit].
(-->107)
134 VQT3G90