Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Function Remotes - Craftsman 139.53939D Owner's Manual

PROGRAMMING
NOTICE: ff this Security,Y _garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumventec_ The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button
Below are instructions for programming your opener to operate with additional Security÷ ® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE "LEARN" BU'I-I'ON USING THE SMART CONTROL PANEL
TM
s_
1_Press and release the "learn" button
on the motor uniL The leam indicator
light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your garage
door.
3o Release the button when the motor
unit lights blink. It has leamed the
code_ If light bulbs are not installed,
two clicks will be heard.
1. Press the Learn button on the Smart
Control PaneFM.
2. Press the Learn button again to confirm
Learn Mode.
3 Press the button on the hand-held
remote* that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the purple "learn" button on
motor unit until the learn indicator light goes
out (approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use..
*3.Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any Security÷ °
3-Function remote or _"_"_'_A ._'_
compact remote can be
programmed to operate "
other Security+" garage
door openers.
37