Connect The Door Arm To The Trolley - Craftsman 139.53939D Owner's Manual

INSTALLATI]ON STEP 13
Connect Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page
SECTIONAL DOORS ONLY
Make sure garage door is fully closed Pull the
emergency release handle to disconnect the outer trolley
from the inner trolley Slide the outer trolley back (away
from the pulley) about 8" (20 cm) (Figures 1,2 and 3)_
Figure 1:
. Fasten straight door arm section to outer trolley with
the 5/16"x1" clevis pin Secure the connection with a
ring fastener.
• Fasten curved section to the door bracket in the same
way, using the 5/16"x1-1/4" clevis pin.
Figure 2:
° Bring arm sections together_ Find two pairs of holes
that line up and join sections. Select holes as far apart
as possible to increase door arm rigidity.
Figure 3, Hole alignment alternative:
• If holes in curved arm are above holes in straight arm,
disconnect straight arm. Cut about 6" (t5 cm) from the
solid end. Reconnect to trolley with cut end down
as shown.
° Bring arm sections together.
- Find two pairs of holes that line up and join with bolts,
lock washers and nuts.
Pull the emergency release handle toward the opener at
a 45" angle so that the trolley release arm is horizontal
Proceed to Adjustment Step 1, page 27. Trolley will
re-engage automatically when opener is operated_
Clevis Pin
5/16"xl -I/4"
Figure 1
Door Bracket
Figure 2
" Outer
Trolley
5/16"x1"
Emergency
• Release
Handle
DoorArm
Cu_ed DoorArm
HARDWARE SHOWN ACTUAL SIZE
©
Nut 5/16"_18
Clevis Pin
5/16"x!" (TroIIey)
Lock Washer 5/16" Ring Faslener
Clevis Pin Hex Bolt
5/16 x1-1/4 (Door Bracket) 5/16"-18x7_"
Figure 3
25