If A Notice Page Is Printed - Sharp AR-M250 series Online Manual

6 TROUBLESHOOTING

If a notice page is printed

If you find that a notice page has been printed at the end of a print job, the print data received from the computer has not been
printed as specified. Fix the problem as explained below and then try printing again.
Notice Page regarding memory full on IMC board
****************************************************
Notice Page
****************************************************
The IMC memory full error had occurred,
a normal output was not able to be executed.
Please refer to the operation manual for
the solution method.
When the Staple function is not selected:
●
Disable the ROPM function by removing the checkmark from
"ROPM" in the "Configuration" tab of the printer driver setup
screen. (See "CONFIGURING THE PRINTER DRIVER" in the
software setup guide for network printer.) If you need to use the
ROPM function, lower the resolution setting in the printer driver
or install more memory.
When the Staple function is selected:
●
Lower the resolution setting or increase the "MEMORY FOR
PRINTER" setting in the key operator programs. If this does not
resolve the problem, install more memory.
CONTENTS
The IMC memory is used to store print data when the
Note
ROPM function is used. This memory is also used to store
original image data in the copy mode. The percentage of
IMC memory allocated to the printer function can be
adjusted using a key operator program. See "MEMORY
FOR PRINTER" in the key operator's guide. The memory
can be extended by adding commercially available
memory modules. For details, contact your SHARP dealer.
When data loss error has occurred:
****************************************************
Notice Page
****************************************************
The data loss error had occurred, a normal
output was not able to be executed.
Please refer to the operation manual for
the solution method.
• Set the page protection function or enable the ROPM function.
To enable the ROPM function, select the "ROPM" checkbox in
the "Configuration" tab of the printer driver setup screen. (See
"CONFIGURING THE PRINTER DRIVER" in the software
setup guide for network printer.)
☞
PAGE PROTECTION
(part 1)
74