Toshiba Tecra M5 Maintenance Manual page 305

4.26 Finger print sensor board
Installing the Finger print sensor board
To install the finger print sensor board, follow the steps below and refer to Figure 4-48.
1. Connect the finger print sensor cable to the connector on the finger print sensor
board.
2. Place the finger print sensor board in place while inserting the connecter side into
the guide.
3. Place the bracket while sliding it into the guide.
4. Stick the glass tape on the finger print sensor cable.
5. Pass the speaker cable through the guides.
TECRA M5 Maintenance Manual (960-542)
4 Replacement Procedures
[CONFIDENTIAL] 4-69