Toshiba Tecra M5 Maintenance Manual page 292

4 Replacement Procedures
7. Disconnect the DC-IN jack cable from the connector CN8800 on the system board
and remove the DC-IN jack from the slot.
DC-IN jack
DC-IN jack cable
Figure 4-39 Removing the system board/HDD cable/DC-IN jack (4)
Installing the System board/HDD cable/DC-IN jack
To install the system board/HDD cable/DC-IN jack, follow the steps below and refer to
Figure 4-36 to 4-39.
1. Connect the DC-IN jack cable to the connector CN8800 on the system board.
2. Connect the HDD cable to the connector CN1850 on the back of the system board
and stick the insulator on the connector.
3. Install the system board to the base assembly.
4. Install the DC-IN jack to slot of the base assembly.
5. Connect the LAN cable and modem cable to the connectors CN4100 and CN3011
on the system board.
6. Place the HDD cable and stick the glass tape in place.
7. Set the HDD cable to the HDD cable holder B.
8. Install the HDD cable holder B (with the HDD cable) on the slot of the base
assembly.
9. Install the HDD cable holder A on the slot of the base assembly.
4-56
CN8800
[CONFIDENTIAL]
4.20 System board/HDD cable/DC-IN jack
TECRA M5 Maintenance Manual (960-542)