Changing Power-Save Mode Settings (Power-Save) - Ricoh Caplio G3 Operation Manual

Changing Power-Save Mode Settings (Power-Save)

You can reduce the power consumption of the LCD Monitor and extend the life of your batteries.
At the time of purchase, Power-Save Mode is set to [OFF].
Possible Settings
OFF (Power-Save Mode Inactivated) (Set at purchase)
ON (Activate Power-Save Mode)
To change the Power-Save Mode, follow the
steps below.
Turn the Mode Dial to 1 (Setup Mode).
The Setup Screen appears.
If you have activated Power-Save mode, power consumption will be less, but there are the following limitations.
• The display on the LCD Monitor will turn off. Press the Q (Quick Review) button or the M button to turn
the LCD Monitor Display on, and then press them again to turn the display off. You cannot turn the LCD
Monitor Display on/off by pressing the T (Self-timer), F (Flash) or N (Macro) buttons.
• Processing time may be slower.
• It works only in Shooting Mode. It does not work in Playback Mode.
Chapter 1 / Section 6 Changing Camera Settings
Press the " button to select [POWER
SAVE].
Press #$ to select the desired setting.
This setting will be used until you change it.
114